top of page
IMG_0043.jpeg

Included Hardware

#6 Screw PNG.png

#6 Screw (x2)

Untitled design-3.png

Anchor for drywall, plaster, or paneling  (x2)

Hex Cap.png

Screw-cap (2x)

Screenshot 2026-02-17 at 1.57_edited.png

Threaded Stud (x2)

Untitled design-4_edited.png

Swivel Crossbar

Installation

  ​

First, Use the #6 screws and anchors* to affix the crossbar to your wall.

Screenshot 2026-02-17 at 2.39.06 PM.png

  ​

*The anchors are intended for use with drywall, plaster, or panelling.  They will require 3/16" pilot holes. If you're mounting into a different material you may need to source different anchors

  ​

Now, screw those threaded studs into the crossbar...

Screenshot 2026-02-17 at 2.49.38 PM.png

  ​

You're almost done! Now, you'll place the light fixture over those threaded studs. Adjust the orientation so that the wire comes straight down from the bottom.

​

Thread the screw-caps onto the studs and tighten until the backplate doesn't move when you adjust the shade.

​

Now pop in a bulb, and enjoy! We recommend an LED A15 bulb of any wattage-equivalency :)

Care

​

Wipe with a soft, dry cloth.  Avoid any harsh cleaning chemicals as they will damage the finish.

Thank you

Thanks so much for supporting our little studio!  

​

As a thank-you for your support, please use discount code HELLOAGAIN for a small discount on your next order :)

​

​

bottom of page